Commercial HVAC Installation & Rooftop Unit Replacement
Sized by load calculation, installed to mechanical code, scheduled so your doors stay open.
(336) 318-5876
Free Commercial Equipment Assessment
We survey the building, run the load, and quote real options — no pressure, no mystery line items.
Licensed mechanical contractor #36703 • Permits and inspection handled
Quick Answer:
Dependable HVAC installs and replaces commercial HVAC equipment — rooftop units, commercial split systems, VRF, and packaged heat pumps — for businesses in Stanly and Montgomery County, NC. Load-calculated sizing, permitted work, off-hours scheduling. Call (336) 318-5876 for a site assessment.
Which Commercial System Fits Your Building?
The right answer depends on roof structure, tenant layout, and how the space is occupied — not on whatever was installed there twenty years ago.
Rooftop Unit Change-Out
Best for: Retail, restaurants, offices with existing curbs
Crane set, curb adapter fabrication where the new footprint differs, gas and electrical reconnection, and controls transfer — usually done in a single overnight or weekend window so you never close.
Commercial Split System
Best for: Buildings without roof access or curb structure
Ground-set or pad-set condenser with an indoor air handler or furnace in a mechanical closet. Easier service access and often a lower install cost when no curb exists.
VRF / VRV Zoning
Best for: Multi-tenant suites, medical offices, historic buildings
One outdoor unit feeding multiple indoor heads with independent setpoints per space, plus simultaneous heating and cooling on heat-recovery systems. Minimal ductwork in buildings that can't accept trunk lines.
Packaged Heat Pump
Best for: Churches, daycares, small warehouses
Single all-in-one unit handling both seasons with no indoor mechanical room required — simple, serviceable, and efficient for intermittent-occupancy buildings.
Our Commercial Installation Process
Load calculation and equipment survey — we measure the building, not the nameplate on the old unit.
Written proposal with equipment options, efficiency tiers, and expected operating cost differences.
Permits and mechanical code compliance handled by us as your licensed contractor.
Installation scheduled outside operating hours, with crane and rigging coordinated in advance.
Startup, charge verification, airflow balance, and controls commissioning with documented readings.
Warranty registration and a maintenance schedule handoff so the new equipment stays covered.
Repair or Replace? The Honest Threshold
A commercial rooftop unit past 12–15 years with a failed compressor or a leaking evaporator coil is usually a replacement conversation, especially on R-22 equipment where refrigerant cost alone makes repair uneconomical. Under 10 years with a control or motor failure, repair almost always wins.
We price both and hand you the comparison. Businesses make capital decisions on numbers, not pressure — and if the repair is the right call, we'll say so and handle the commercial repair instead.
Commercial Installation Questions
How long does a commercial rooftop unit replacement take?
How do you size commercial HVAC equipment?
Can you replace one rooftop unit without disturbing the rest?
Do you handle permits and mechanical code as the contractor?
Plan Your Commercial Equipment Replacement
Get a site assessment, a load calculation, and a written proposal you can take to ownership.
Call (336) 318-5876